Scissor Lift Certification Kelowna

Scissor Lift Certification Kelowna - Scissor lift platforms are used at work places to be able to enable tradespeople - like for example iron workers, welders and masons - to reach their work. Operating a scissor lift platform is usually secondary to their trade. Thus, it is essential that all platform operators be correctly trained and licensed. Industry, lift manufacturers and regulators all work together to make certain that operators are trained in safely utilizing work platforms.

Scissor lift work platforms are otherwise known as manlifts or AWPs. These work machines are rather simple to use and offer a steady work surroundings, then again they do have risks as they raise people to heights. The following are several important safety concerns common to AWPs:

To protect those working around work platforms from accidental power discharge due to close working proximities to wires and power lines, there is a minimum safe approach distance (also referred to as MSAD). Voltage could arc across the air and cause injury to staff on a work platform if MSAD is not observed.

In order to ensure maximum steadiness, caution must be taken when the work platform is lowered. When you move the load towards the turntable, the boom must be retracted. This will help maintain stability during lowering of the platform.

The regulations about tie offs do not mandate those working on a scissor lift to tie themselves off. Some organizations will on the other hand, require their workers to tie off in their employer guidelines, job-specific risk assessments or local regulations. The anchorage provided by the manufacturer is the only safe anchorage wherein lanyard and harness combinations should be attached.

It is essential to observe and not go over the maximum slope rating. The grade can be measured by laying a straight edge on the slope or by laying a board. A carpenter's level could then be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, the per cent slope could be determined.

To be able to determine whether the unit is mechanically safe, a regular walk-around inspection should be performed. Work site assessments are also essential to make sure that the work area is safe. This is important particularly on changing construction sites because of the possibility of obstacles, contact with power lines and unimproved surfaces. A function test has to be carried out. If the unit is used properly and safely and correct shutdown measures are followed, the possibilities of incident are greatly lessened.

Click to Download the pdf